A simulation of power conversion from three-phase to high-frequency single-phase with a matrix converter assuming a quick charger and a non-contact power supply device.

- Categories:

**In this simulation, the phase difference of the signals a, b, and c in the paper is changed to 0 in 0.1 seconds from the state where the phase is 90 degrees different from the input voltage. The input current phase is the same as the above signal. Since the output voltage gradually increases, it can be seen that the DC voltage of the matrix converter increases as the phases of a, b, and c become closer to the input voltage phase. Strictly speaking, it is proportional to cosθ as described in the paper.**

- Categories:

This dataset contains the data associated with the electrically equivalent model of the IEEE Low Voltage (LV) test feeder for use of the distribution network studies. This dataset is for the letter entitled:" A Reduced Electrically-Equivalent Model of the IEEE European Low Voltage Test Feeder".

The uploaded data includes a zip file containing the dataset in the form of CSV files for an electrically equivalent reduced model of IEEE LV European feeder.

- The test feeder is at the voltage level of 416 V, phase-to-phase.
- Load shapes with one-minute time resolution over 24 hours are provided for the time-series load flow simulation.
- Line data and load data of the network are given in seperate CSV files.
- The line codes specified by sequence impedances and admittances are available in a seperate CSV file.

- Categories:

The compressed (. zip) file includes the codes for Response Letter of Paper TPWRS-00778-2020.

- Categories:

This paper proposed an optimized zero-state replacement (ZSR) method for general Bi-tri logic SPWM (BTSPWM) to deal with the common-mode voltage (CMV) issue. The BTSPWM can take advantage of the well-developed modulation strategies adopted in voltage source converters (VSCs) and transfer them into a current source converter (CSC) system through logic translation, which shares more general features compared with other modulations developed for CSC.

- Categories:

Solar power geneartion from 2018 to 2019 at a 3kW rooftop pv plant in the university of macau, with a resolation of 30 s, and the public weather report of Macau with a resolution of 1 hour.

- Categories:

A dataset to accompany the "Detrending and Characterizing System Frequency Oscillations Using an Adapted Zhou Algorithm" article submitted to IEEE Transaction on Power Systems

It contains the Single Freqneuy Model used to create data for the study involved in the paper, & a python based program that impliments the method propsed in said paper

- Categories:

DC-link dynamic is one of the most important issues for current source converters (CSC). In practice, the dc-link voltage suffers from the slow dynamic due to grid disturbances, which will affect the quality of output waveform and damage the converter. Many solutions have been presented to cope with it, but none of them achieve the zero dynamic dc-link voltage control. In order to fill the technical gap, a novel solution is proposed in this paper.

- Categories:

This data-set consists of 3-phase differential currents of internal faults and 4 other transients cases for Phase Angle Regulators (PAR). The transients other than faults include magnetizing inrush, sympathetic inrush, external faults with CT saturation, and overexcitation conditions. PSCAD/EMTDC software is used for simulation of the internal faults and the transients.

The files - ’fault_location_pha’, ’fault_location_phb’, and ’fault_location_phc’ have phase a,b,c differential currents for 46872 cases. Each row has 167 samples (one cycle). In fault_location_target’- the first 33480 are faults in series unit, next 13392 are faults in exciting unit. The files - ’transients_pha’, ’transients_phb’, and ’transients_phc’ have phase a,b,c differential currents for 13680 cases. Each row has 167 samples (one cycle). In fault_transient_target’- the first 720 - overexcitation, next 2520 - magnetizing inrush, next 2520 -sympathetic inrush, and next 7920 are external faults.

- Categories:

Multiwinding-Transfomer-based (MTB) DC-DC converter did emerge in the last 25 years as an interesting possibility to connect several energy systems and/or to offer higher power density because of the reduction of transformer core material and reduction of power converter stages. MTB DC-DC converters can be considered as an interesting compromise between non-modular and a modular DC-DC converter since they are themselves modular in the construction.

- Categories: